Are you a Toyota Kluger owner wondering how to access your spare tyre in times of need?
Our step-by-step guide will walk you through the process, ensuring you can confidently handle a tyre change whenever the need arises.
Start by opening the rear hatch of your Toyota Kluger.
You can do this by pressing the hatch release button on your key fob or by using the manual release located on the rear of the vehicle.
This panel is a cover that conceals the spare tyre and is typically situated beneath the cargo area floor. Specifically, you’ll find it to the right of the centre.
The next step is to remove the panel covering the spare. This is done by pulling up on the tab located at the bottom of the panel.
Be gentle but firm to avoid damaging the panel.
Now that you’ve uncovered the spare tyre, you’ll notice a winch cable attached to it.
This winch cable is a crucial component of the spare tyre system, as it allows you to raise and lower the spare tyre as needed.
To access the spare tyre, turn the winch crank counterclockwise.
As you turn the crank, you’ll notice that the spare tyre begins to lower gradually. Continue turning the crank until the spare tyre is fully lowered to the ground.
Once the spare tyre is safely on the ground, disconnect it from the winch cable. This step ensures that the spare tyre is completely separated from the winch system, allowing you to remove it from the vehicle.
With the winch cable disconnected, you can now remove the spare tyre from its location.
Carefully lift the spare tyre out of the storage area. Be mindful of the tyre’s weight and size to avoid any strain or injury.
Remember to periodically check the condition of your spare tyre to make sure it’s in good working order when you need it most.
I'm Louis, an engineer passionate about helping Australians choose better tyres for their vehicles!